PDA

View Full Version : M30 Cyl Head Removal Help



zygoteer
07-09-2005, 11:38 AM
To do this I obviously have to remove the cam chain, but the manuals say :
" - remove distributor cap and rotor from front of camshaft."
" - remove rotor adaptor from camshaft."

I have removed the rotor (3 bolts), but does anyone know how this 'rotor adaptor' is attached ?

It doesn't want to pry off and there seems to be no centre fastener/bolt etc.

The picture shows the adaptor, but the shield on my M30 cannot be withdrawn over it as it it has a smaller centre hole.

The car in in pieces on my driveway ! ... so thanks in advance for your help.

632 Regal
07-09-2005, 12:40 PM
bump...sorry for lowering you 10 spots so I put you back...lol

Bill R.
07-09-2005, 12:50 PM
clean yours out to see it.






To do this I obviously have to remove the cam chain, but the manuals say :
" - remove distributor cap and rotor from front of camshaft."
" - remove rotor adaptor from camshaft."

I have removed the rotor (3 bolts), but does anyone know how this 'rotor adaptor' is attached ?

It doesn't want to pry off and there seems to be no centre fastener/bolt etc.

The picture shows the adaptor, but the shield on my M30 cannot be withdrawn over it as it it has a smaller centre hole.

The car in in pieces on my driveway ! ... so thanks in advance for your help.

zygoteer
07-09-2005, 01:05 PM
clean yours out to see it.OK, I looked again.. cleaned out the gunge ... found a hex drive bolt !

It was very very tight ... but its off now :)

Many thanks "Bill R."