M51 DDE Fault Code 19?

[High Compression II]

Has anyone any idea what the fault code 19 is for the above, its a 1994 vehicle.
One long flash followed by 19 short blinks after the accelerator pressed 5 times. The vehicle appears to run normally

Thanks!

[shogun]

As your car is a EU model, I do not think you can get stomp codes at all. 19 is not a code according to my knowledge. It must be 4 digits. See the procedure and the codes on my website below. Th stomp test was a requirement for US specification cars only.
If you type in stomp test in the search, you will find a lot of postings about this subject.

[High Compression II]

With the DDE, the fault codes are one or two digits as far as I can tell from looking at various 'Plug-In' tester vendors, however, they dont say what code 19 is!

[iainand]

i cant find a reason for code 19

you will get different codes depending on version of DDE your car has, i would assume yours has DDE1 (as does mine) DDE2 seems to have immobiliser too.

[romus]

i've got it on mine too, and it's in australia

[romus]

my idle is varying and not running soothly all the time but still i only get 1444 (no fault)

[High Compression II]

So much for 'Only US cars have stomp test'!
Guess it the luck of the draw as to which non US cars have stomp test capability!

[shogun]

Read the archives.
That has been discussed on various boards all over the world for more than 2 years.
Some people even mix up check control warning messages with stomp test.
Anyway, seeing is believing. So you see it, and then just be happy. ;)