535iTm now has 750 miles......

[Scott H]

Things are looking good. Complete web page coming soon. I have a lot of people to thank!!!

http://www.hersted.org/535iTm%20Project/IMG_1167.JPG

[kyleN20]

looks good, you going to cut the gauges to fit?

[Scott H]

do you know how much room is back there? That plate is a temp until I can make a nicer one. Didn't feel like spending $200 on the hartge panel. You need decent clearance back there and that requires the gauges to be held out a little.


looks good, you going to cut the gauges to fit?

[632 Regal]

are the gages hooked up? If so whats the pressures and temps like when fully warm?

[angrypancake]

thats awesome. and inspiring.

[Scott H]

180F oil temp (gauge is a bit inaccurate considering it's location...will move it soon)
20psi at idle when fully warm and up to 60psi when operating (check valve on oil pump cuts it at 60psi)

:D


are the gages hooked up? If so whats the pressures and temps like when fully warm?

[calmloki]

Outstanding work! Much in the way of niggling little problems to work out yet, or did you get it all perfect right off the bat? I'm impressed.
Tom Walrod

[Scott H]

but other than forgetting to swap the starter relays and tighten the tensioner plug :( , it really seems to be just fine!


Outstanding work! Much in the way of niggling little problems to work out yet, or did you get it all perfect right off the bat? I'm impressed.
Tom Walrod

[kyleN20]

so when you get a nicer one will it sit that far out, or will it snug under the ash tray?/

[Scott H]

we'll see. Dinan and Hartge ones are NLA....gotta find them used/second hand


so when you get a nicer one will it sit that far out, or will it snug under the ash tray?/

[Incantation]

get on the dyno

[Scott H]

I rebuilt a bone stock M30. I can check compression and leak down numbers and as long as those are fine, it will be what it will be.


get on the dyno

[Jeff N.]

...if you did, you'd be discovering loose nuts and bolts for months to come! :D



but other than forgetting to swap the starter relays and tighten the tensioner plug :( , it really seems to be just fine!

[misfortune]

yo where can I get clean shift boot + knob like yours? Tan...

[liquidtiger720]

Awsome job Scott. Major Props.

[Jon K]

I need to do something for gauges soon, argh not fun.

[632 Regal]

if nothings wrong, you dont need them...:p
I need to do something for gauges soon, argh not fun.