View Full Version : M50 timing chain mileage
Espen
07-11-2006, 06:57 AM
How long can the timingchain last? My car have 230 000km now.
Should I get it replaced? Is that something I could do myself? What parts do I need? there are 3 chains right?
yaofeng
07-11-2006, 07:23 AM
143k miles is young. There is no need to replace it at that mileage. Yes there are three chains. The secondary between the two cam sprockets, the main between the exhaust cam sprocket and the crankshaft, and one between the oil pump sprocket and the crankshaft.
Mendozart
07-11-2006, 10:09 AM
The chain should be good for the life of the engine.
Espen
07-12-2006, 07:51 AM
The chain should be good for the life of the engine.
I hear the same thing when i asked about that regarding my previous car, a ford sierra with a 2 litre dohc engine "nah that chain lasts as long as the rest of the engine"
"Bang" at 205 000km the chain snapped, and I had to buy a new engine.. ;)
Just want to make sure this is not true for the M50.
632 Regal
07-12-2006, 08:47 AM
they are made to last a very very long time....this isnt a Frod.
Espen
07-12-2006, 10:25 AM
Ok... I saw a "high performance" chain kit at a local bmw tuning shop.
They said it was a must for bmw`s with a chip. (higher revs)
632 Regal
07-12-2006, 10:37 AM
dont forget the braided radiator hoses and yellow racing wires.
:D
Espen
07-12-2006, 11:09 AM
haha!
Yeah got your point... But i think its a serious store..
"V.S motor" (built the M5 3,8 - 1129bhp / 1130Nm 833ft.lbs torque
I got my answers, so if i snap my chain im gonna blame you guys :)
632 Regal
07-12-2006, 11:33 AM
LOL well if your putting out 1100hp I WOULD recommend the new chains
haha!
Yeah got your point... But i think its a serious store..
"V.S motor" (built the M5 3,8 - 1129bhp / 1130Nm 833ft.lbs torque
I got my answers, so if i snap my chain im gonna blame you guys :)
e39dream
07-12-2006, 11:41 AM
bottom line this isn't a ford where you undo 3 bolts and it falls off, the chains require a decent amount of mechanical ability, as well as some special tooling- one just to hold the cams in place IIRC.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.