BillionPa
01-21-2007, 04:02 AM
M60 DME Engine Control Module EPROM Programming Update without EWS11
Model:
E31, E32, E34 and E38 vehicles with M60 engines produced before January 1995 (automatic transmission).
Complaint:
The check engine light illuminates when going downhill, which has set FC 201/203, when the engine is warming up there is little acceleration, when the vehicle is reversing during the depression and release of the accelerator a slight vibration is felt, when engine is cold or below 40 C it is difficult to start.
Remedy:
Replace the EPROM and reprogram it using V6.0 software or higher, once the EPROM has been reprogrammed it will need at least 10-20 minutes to re-adapt under a variety of load conditions.
..... so as long as the car has power and starts ok, no problem!
Model:
E31, E32, E34 and E38 vehicles with M60 engines produced before January 1995 (automatic transmission).
Complaint:
The check engine light illuminates when going downhill, which has set FC 201/203, when the engine is warming up there is little acceleration, when the vehicle is reversing during the depression and release of the accelerator a slight vibration is felt, when engine is cold or below 40 C it is difficult to start.
Remedy:
Replace the EPROM and reprogram it using V6.0 software or higher, once the EPROM has been reprogrammed it will need at least 10-20 minutes to re-adapt under a variety of load conditions.
..... so as long as the car has power and starts ok, no problem!