Help removing door handle trim...

[Bigezvol]

I have new rubber to put behind the door handle trim pieces, but I am not sure how to remove the plastic trim around the door handle.

Any help is greatly appreciated!

[George M]

Open each door and at the same level as the door handle on the back of each door is an oblong hole with a rubber grommet in it. Remove the grommet and you will see a lever/latch that secures the outer door handle cover to the outer door skin. Use a long narrow blade screw driver through the oblong hole to move the latch to one side to remove retention of the handle cover. Installation is reverse of the former :-)
HTH,
George

[Bigezvol]

Thanks Goerge, found it right after I posted. I sometimes forget to listen to the other side of my brain it think to look at directions.

Got them installed. They make the door handles look much better.

[Super90]

George, can one replace the whole handle the same way?!

Mine are looking a little ratty. That seal is shot, and needs to be replaced, but I was thinking about just replacing the whole handle. Or is that much more difficult?

TIA

[winfred]

gotta take the door apart, and the handle assy is pricey


George, can one replace the whole handle the same way?!

Mine are looking a little ratty. That seal is shot, and needs to be replaced, but I was thinking about just replacing the whole handle. Or is that much more difficult?

TIA

[Super90]

Part# for the seals? Last time I asked, I think Patrick at BMA said they don't sell those seals separately. I seem to remember him saying you had to buy the whole handle assembly. Anyone have a part# for just the seals?

Thanks,

[Paul in NZ]

my latch slides forward to release the outer trim and dlides back to secure