Ross
03-12-2007, 03:48 PM
I've just changed the ABS accumulator on an old Jeep XJ Cherokee equipped with the Bendix10 ABS system, the part was used but assumed good.
I am unsure how to bleed the booster portion of this system. There are no bleed screws I can find so I've loosened the fittings and got lots of air but I want to be sure all of it is out before blaming the "new" part.
The pump cycles instantly on every brake application so I know the pressure isn't retained but don't know if it's because of air or a bad part.The pump and actuator/master are new btw.
Any of you guys familiar with this system??
I am unsure how to bleed the booster portion of this system. There are no bleed screws I can find so I've loosened the fittings and got lots of air but I want to be sure all of it is out before blaming the "new" part.
The pump cycles instantly on every brake application so I know the pressure isn't retained but don't know if it's because of air or a bad part.The pump and actuator/master are new btw.
Any of you guys familiar with this system??