TC535i
04-11-2007, 12:28 PM
Hey guys, my Cruise Control wire had a bad bushing where it connects to the throttle assembly, and was holding the throttle down (stuck) even when I'd let off the gas. :(
Managed to disconnect it up top and keep it from happening, look in the ETK, and you can't buy the bushing... you buy a whole new cable assembly. Fine.
Ordered the cable, comes with all the stuff, go to swap em out... and the stock one is kinda "stuck" inside the cruise control motor. I can't figure out how to disconnect the thing, and I can only get a good look at the new one, since the old one is kinda in an awkward place.
Anyone replaced the cable before? Tips/tricks??
Thanks!
-Tim
Managed to disconnect it up top and keep it from happening, look in the ETK, and you can't buy the bushing... you buy a whole new cable assembly. Fine.
Ordered the cable, comes with all the stuff, go to swap em out... and the stock one is kinda "stuck" inside the cruise control motor. I can't figure out how to disconnect the thing, and I can only get a good look at the new one, since the old one is kinda in an awkward place.
Anyone replaced the cable before? Tips/tricks??
Thanks!
-Tim