PDA

View Full Version : HID/light problem



liquidtiger720
05-05-2007, 01:29 AM
One of my lights is inoperable right now. Earlier in the week, the lights were fine...but today the light didnt fire up, but blew a fuse. I replaced the fuse, but it blew immediately. Could a short in the ballast cause this? It looks like water got to it as the casing is a little dirty and has slight rust coloration. Any other thoughts on where a short may occur?

attack eagle
05-05-2007, 03:09 AM
you are probably looking at replacing the ballast. Try swapping bulbs side to side to make sure, and or the ballast themselves but I'd lay money your ballast went **** up.

Tiger
05-05-2007, 06:39 AM
If you disconnect the ballast, does the fuse still blow?

Like eagle said... if you swap ballast around, does the fuse blow on that side?