KurtM
05-20-2007, 08:01 PM
I recently asked for some help with a trans program message after changing fluid and filter and followed Shogun info page instructions and no changes, message is still displayed. Purchased a fault code reader off EBay (Bavarian Autosport) and it displays no faults. Wanted to make sure it worked so I reset service lights.
Cleaned all connectors and switches shown from Bruno's site and from previous posts on this site.
I did the computer reset also. No changes.
Any ideas would be very helpful. Someone said I might have pinched a wire when putting pan back on, I don't really want to drop the pan but maybe that is the next step.
Any other suggestions prior to dropping pan would be appreciated.
Thank you,
Kurt
95 525ia
Cleaned all connectors and switches shown from Bruno's site and from previous posts on this site.
I did the computer reset also. No changes.
Any ideas would be very helpful. Someone said I might have pinched a wire when putting pan back on, I don't really want to drop the pan but maybe that is the next step.
Any other suggestions prior to dropping pan would be appreciated.
Thank you,
Kurt
95 525ia