PDA

View Full Version : alarm won't shut off



myles
04-27-2008, 02:57 PM
Try to disconnect the 20(something) pin connector from the dwa module. (Thats the module that you pulled the fuse from). That should bring your OBC back to life and hopefully not set off the alarm.

gpljrrr
04-27-2008, 03:09 PM
1995 e34 540i with three button key/alarm transmitter i set the alarm and when i tried to disarm,i could not. the only way i could get up and running was to pull the fuse from the module (under rear seat, drvrs. side forward of all other modules at benchseat bulkhead) since then i have disconnected battery, shorted cables, etc. but when i install fuse alarm is activated again. FYI removing this fuse also prevents the OBC from operating.

pgrindstaff
04-27-2008, 08:20 PM
Are you referring to fuse 47, which the fusebox lid says is for the Airbag?

myles
04-30-2008, 11:19 AM
Is the alarm still going off with the dwa module removed?

gpljrrr
04-30-2008, 06:17 PM
Are you referring to fuse 47, which the fusebox lid says is for the Airbag?
no, fuse at top of module under benchseat

gpljrrr
04-30-2008, 06:32 PM
Try to disconnect the 20(something) pin connector from the dwa module. (Thats the module that you pulled the fuse from). That should bring your OBC back to life and hopefully not set off the alarm.
got my new transmitter today and removed module from car completely disconnected all plugs from module disconnected battery terminals followed the "new transmitter initialazation procedure in owners manual" still cannot get the alarm to deactivate????

gpljrrr
05-02-2008, 06:53 PM
Is the alarm still going off with the dwa module removed?
no