Jehu
07-07-2016, 11:10 AM
My e-box fan is not working.
My DME's are overheating in this Summer heat and when they get hot enough the engine runs roughly at idles.
The reason I connect them is I have two DME's .
I can swap in a cool unit and the idle smooths out.. then I can replace the DME after the hot one cools and again the engine is smooth at idle.
Perhaps the DME units suffer from some weakening solders on the circuit boards.
I also discover there is a relay socket lacking a relay so wondered if the e-box fan is run off that.
All the wiring for the fan and tenp sensor seems to be intact.
I tried searching for "ebox relay" but didn't actually locate any specific reference to one.
My DME's are overheating in this Summer heat and when they get hot enough the engine runs roughly at idles.
The reason I connect them is I have two DME's .
I can swap in a cool unit and the idle smooths out.. then I can replace the DME after the hot one cools and again the engine is smooth at idle.
Perhaps the DME units suffer from some weakening solders on the circuit boards.
I also discover there is a relay socket lacking a relay so wondered if the e-box fan is run off that.
All the wiring for the fan and tenp sensor seems to be intact.
I tried searching for "ebox relay" but didn't actually locate any specific reference to one.