Subframe bushing tool - I need one.

[JoeS]

Anyone have one to put up on the tool loaner program? I will pay shipping both ways.

I don't want to pay big money for something I will only use once.

[ryan roopnarine]

have you considered this?


http://www.koalamotorsport.com/mall/toolprice.htm

75 is kinda expensive....maybe one of the people on the board with a homebrew unit can set you up with theirs.



Anyone have one to put up on the tool loaner program? I will pay shipping both ways.

I don't want to pay big money for something I will only use once.

[JoeS]

If i were going to spent $75 , i would just put it toward the purchase of one.

[bfd]

If i were going to spent $75 , i would just put it toward the purchase of one.

Agree, but doesn't the *official* BMW tool cost like $350! That's alot of money to spend for a one time use. The question I have is whether somebody like Snap-on, Mac, SK, etc., might make a puller that would work?

[ryan roopnarine]

these peole might be able to get you one for ownership

http://www.samstagsales.com/bmwtools.htm#toolkit

[George M]

Joe...send me an e-mail at: mann15@msn.com.
George