notesguy
07-31-2004, 06:32 AM
I bled the cooling system.
After the bleeding and while it was running warm (1/2 way mark), I saw it still let some steam out of the bleed screw.
Did I tighten it enough?
How tight should it be?
Any ideas on creative tools to tighten it?
In the past, I tightened an old one too tight and it stripped - cost $50 for fealer to fix.
Many thanks!
After the bleeding and while it was running warm (1/2 way mark), I saw it still let some steam out of the bleed screw.
Did I tighten it enough?
How tight should it be?
Any ideas on creative tools to tighten it?
In the past, I tightened an old one too tight and it stripped - cost $50 for fealer to fix.
Many thanks!