silverz06vette
11-15-2004, 05:59 PM
Well my drivers side exterior door handle would get stuck in the open position.
I found this thread:
http://www.bimmer.info/forum/showthread.php?p=31755&highlight=door+handle
Could not get the handle to adjust high enough to avoid the problem.
So I wanted to take the handle out to see what else could be done. Followed the process in the Bently for the most part.
Only thing I could not get done is to #4 in the above link: disconnect the locking linkage. So I did the rest of the steps thinking it would be easier to get the linkage disconnected, no luck!!!
So now the handle will not even go back into place to reinstall it. Best of all my shop light burned out the small bulbs that it uses and my rechargable flashlight is done too. :(
HHHEELLLPPP!!!
I think I need a beer.
I have had the same handle out on our old 93 740 once a few years ago.
I found this thread:
http://www.bimmer.info/forum/showthread.php?p=31755&highlight=door+handle
Could not get the handle to adjust high enough to avoid the problem.
So I wanted to take the handle out to see what else could be done. Followed the process in the Bently for the most part.
Only thing I could not get done is to #4 in the above link: disconnect the locking linkage. So I did the rest of the steps thinking it would be easier to get the linkage disconnected, no luck!!!
So now the handle will not even go back into place to reinstall it. Best of all my shop light burned out the small bulbs that it uses and my rechargable flashlight is done too. :(
HHHEELLLPPP!!!
I think I need a beer.
I have had the same handle out on our old 93 740 once a few years ago.