my driver door wont open plz help

[ve39]

can any one help me my drivers door wont open at all i can't get that pin up could any one help plz i don't know what to do

[632 Regal]

and turn the key ALL the way and it should unlock, we'll deal with the drivers side after you get in.

[ve39]

i'm in my car but i still can't open the drivers side the pine to open the door is not going up i'm trying as hard as i can

[shogun]

or the microswitch out of order. Provided that the E34 doors are of same or similar design as the E32, I can tell you a little trick how to open the door without breaking anything.
Open the rear door behind rivers door wide.
Use a torch and look between the rear door and the B-pillar. There you can see the edge of the front door. There is a small rubber plug in the front door at the same height as the door handle. Remove this and then you see the slide which holds the door handle from inside.
http://shrubbery.student.utwente.nl/johan/doorlock_microswitch/slider.jpg
Push this slide forward so that the door handle is released. Then you can remove from the outside the door handle of the front door.
Then use the torch again and you will see the doorlock system. Try from the outside with a srewdriver to release the doorlock.
Works on the E32, I hope also on the E34.

Further details how the doorlock looks etc. are on Johan's E32 page

click here (http://shrubbery.student.utwente.nl/johan/doorlock_microswitch/slider.jpg)

[ve39]

so will this fix my problem or it's still ganna be doing this every time i close the door

[ve39]

i don't see any small rubber plug ekk
is there any thing elsy i can do ?

[ve39]

Ok guy with my teeth and some crazy technic i managed to get that pine up and open the door i took the panel off the door and looking inside every thing looks ok and clean could any one tell me what could be broken and what can i do tp fix my problem
thank you

[shogun]

which is moving with a good non-dripping grease. I use grease for motor bike drive chains. This also helps in winter time that the mechanism gets frozen when car is parked outside. After that don't install the door panel, just actuate the lock several time so that the grease goes inside the moving parts. Then try again and when it works attach the doorpanel again.

In the attachment is the explosion drawing. Unfortunately you have not in your profile year built/engine/manual or automatic etc. which would help much in future to answer questions. Maybe you add these items to your profile.

click here (http://www.realoem.com/bmw/showparts.do?model=HD63&mospid=47404&prod=19901100&btnr=41_0731&hg=41&fg=40&PHPSESSID=2f576ced29477680ec938848d4d39ea1)

[ve39]

well every thing seems ok i don't see the problem i was told that it could be a motor in the door that broke could that be the problem ?
my car is BMW 525 1989

[ve39]

hey guys is there no one know a solution to my problem i mean there was other threads like this i see no solution there too
if my english is bad or i didn't explain good here is exact same thread
http://www.bimmer.info/forum/showthread.php?t=5994&highlight=door+lock

thx