Reply With QuoteHere is what I've done from my memory:
Solder (+) and (-) wires to the bulb. I simply inserted the other end into the 9006 plug and taped it up w/ electrical tape.
Major Contributor
QUICK! 9006 to H1 headlamp question.
So as a spur of the moment i decided ot pull of the center trim and all that stuff, and try to put in one side of my hella ee's, but i noticed that the 9006 connector and the h1 connector ont he cap of the euros are wayy different...
are these my only options?
http://www.bimmer.info/forum/showthr...ight=9006+euro
Major Contributor
Here is what I've done from my memory:
Solder (+) and (-) wires to the bulb. I simply inserted the other end into the 9006 plug and taped it up w/ electrical tape.
FS: PBR Deluxe rear brake pads [new]
Major Contributor
So I left my headlights on but put on used euro corners, in thedark, lost 2 screws had to rig a magnet, had a bitch of a time with the center trim but, its all done, it looks sic and im goin out, its friday, hell yea haha
oh, i also figured to get my hid's and my new smoked euros as the same time so i woudlent have to convert any plugs or such, a few weeks and it will be all done, pics tomorrow of the clear corners in the daylight, and i left clear bulbs in, so they flash white
Last edited by BFEINZIMER; 12-16-2006 at 01:44 PM.
Super Moderator
3 Grand Master
Just put spade connectors on the end and seal it up, then you can use H1. Someone did this here, but I forget
4 Grand Master
Yes, the cap requires new connector and spades... You can buy this bekker import or dealer or the retailer who sold you the set. You must use the cap or you are going to have moisture problem.
Posting Permissions
