Power Steering Hose R&R

[johnf]

Hi All,

I'm looking for some info or pointers before I tackle this job.

Is there a writen procedure for replacing the power steering hoses on a '95 540? I searched the forum, but all I found was that the job is a real PITA. And, the Bently manual I have doesn't address the replacement.

Thanks,

Johnf
'95 540i

[shogun]

I do not have a special on the 540. On my E32 750 I had to remove some parts in engine room on driver side above the subecjt and then used a 40 cm long extension with wobble connection, worked fine.
Do not tighten the banjo bolts too tight, they easily break.

[johnf]

I believe I have all the tools required for the job. If it looks other than straight forward, I'll take some pics and create a how-to.

I think the Bentley manual has the proper torque values, but little else. I'll review those when reassembling.

Thanks,
-j

[MBXB]

shogun's pics from the E32 board:

http://www.bimmerboard.com/forums/posts/124919

[EricB]

These are exactly what I was looking for, thanks

shogun's pics from the E32 board:

http://www.bimmerboard.com/forums/posts/124919

[e34musician]

is the procedures the same for M60 engine? I doubt it. I was going to do mine. But I decided to have the my mechanic do it instead. He mentioned that he will have to loosen the engine mount and jack up engine a bit on the left side to change the high pressue host.