Reply With Quotewhooo yeah! that looks like fun!
Grand Master
Sawed off shotgun
Took my shifter knob apart and cut her down. Bored out the center shaft so that the shifter rod would go all the way through to the top of the knob. Left just a little room to attach the knob cover. Wrapped the shaft with Parafilm (wax film), so it can be removed. Filled in the cavity with JB Weld. Must of removed about 3 inches from the height. Man this thing is cool, Shifts sharp and clean. Makes me want to go out and drive, just to shiftLot more room for my coffee mug and ipod too.
Major Contributor
whooo yeah! that looks like fun!
4 Grand Master
... so its not the length that counts?
Haahaha... was wondering about that too.
Nice close up of that lil' stubbie. Beware the pedantics telling you your boot needs a clean...
Join the Aussie 540i LE yahoo forum
08/88 535i e34 M30+miller MAF, 'stiens, tints & teeth!
Major Contributor
Yeah that's what I did with mine. I fitted a short-shift lever from a modded E30, then had the lever height cut right down as short as physically possible - I reckon mine stubbier than yours though!
Cheers,
Shaun M
3 Grand Master
Nearly spilled my drink reading thatOriginally Posted by E34-520iSE
Major Contributor
Just telling you like it is, W-chaser!
Regards,
Shaun M
3 Grand Master
Apologies to all for lowering the tone of the thread
Major Contributor
Didn't lower the tone for me mate, you made me laugh!
Cheers,
Shaun M
3 Grand Master
At least I didnt say 'nearly spilled my drink marra' . I cant even type that with the right accent
Major Contributor
lol soonds aboot reet ta me hinny!
Regards,
Shaun M
Posting Permissions
